Faucet Supply Line Is Too Short? – How to Extend A Water Supply Line

When you buy a faucet, the manufacturer generally offers a faucet supply line as a giveaway. However, sometimes the faucet supply line that may be too short, which is a very common problem. If you come across the same problem, you are in the right place! In this post, we will guide you to fix the problem of the water supply line is too short and extend a water supply line.

Obviously, there must not be any gaps in the water pipes as this would create leaks and would not be able to supply the faucet with the water it needs to operate. But don’t worry. It’s possible to fix this, even for DIYers, so don’t rush to call a plumber.

Extending your supply line doesn’t have to be a big deal. With the right tools, you can do the job in a few hours. While it’s always wise to have your work checked by a professional plumber, homeowners can also do it by themselves.

Tools you need

• Faucet Supply Line Extension
• Teflon tape or sealant
• Tape measure
• Adjustable Wrenches and Pot Wrenches
• Towel
• Bucket
• Flashlight

Steps to extend a faucet supply line

Step 1: Turn off the water. Not just the sink, but the water going to the sink or the home needs to be completely shut down to prevent messy accidents and leaks.

Step 2:Use several coats of Teflon tape or thread sealant on the threaded pieces you will connect first.

Step 3:. Start by attaching the connector to the faucet body.

Step 4: Next, connect the faucet to the sink.

Step 5: Insert the tailpiece and connector into one or more of the holes already drilled in the countertop.

Step 6: Using the rubber washer retaining ring, slide it up and hold the faucet part in place.

Step 7: Tighten the nut with your fingers or a pot wrench. Make sure not to overtighten. Once you have them in place, a quarter turn with a wrench is enough. Excessive tension can damage the countertop.

Step 8:Add a layer of Teflon tape or sealant to the other end of the extender.

Step 9: Connect the extender to your power cord. This is where these labels come in handy. Tighten them with an adjustable wrench, again making sure you don’t overtighten.

Step 10: Finally, you can turn the water back on and check for leaks. You can tighten anywhere you notice water coming out to prevent further problems.

Conclusion on faucet supply line is too short

So that’s it! This is the process of how to extend faucet supply line. If the faucet supply line is too short and you want to extend the faucet supply lines, this is the right process to do it. We hope our guide will help you extend your kitchen faucet supply lines. Here is a video guide.